Home News Airmar TriSonic 2 pairs two sensors for catamarans

Airmar TriSonic 2 pairs two sensors for catamarans

0
Airmar TriSonic 2 uses two of these TriSonic ultrasonic speed and depth sensors, shown beside a phone with speed, depth, temperature, pitch and roll in the Airmar CAST app.
Image: Airmar

Airmar is bringing its TriSonic 2 Dual-Sensor Smart System to METS (Marine Equipment Trade Show) in Amsterdam, 17-19 November on stand 01.205. Airmar TriSonic 2 is a two-sensor version of the TriSonic speed and depth sensor – made for catamarans and other multihulls.

The single TriSonic came out in August. It is an ultrasonic sensor that measures speed through water, depth, water temperature, heel and trim. There is no paddlewheel. Everything goes out on NMEA 2000 (National Marine Electronics Association 2000), so any plotter or instrument on the network can show it.

Airmar TriSonic 2 on a catamaran

On a cat the problem is simple. When one hull lifts, the sensor on that side can end up in aerated water – and the log goes silly. TriSonic 2 uses a port and a starboard sensor that talk to each other all the time. According to Airmar the pair works out which unit sits lowest in the water and switches to that one for speed and depth. On wide catamarans both sensors can run at the same time and give a depth under each hull.

Airmar TriSonic Smart Sensor, a black plastic thru-hull ultrasonic speed and depth sensor with a flush face.
TriSonic Smart Sensor. Image: Airmar

Airmar’s release talks about pairing “a second TriSonic unit”. So our guess is that TriSonic 2 is two standard TriSonic sensors, with Airmar’s patented firmware making them work as one. Airmar hasn’t published a separate part number, so we can’t confirm it.

Setup goes through Airmar’s free CAST app on iOS or Android, over Bluetooth. You can calibrate speed, set depth offsets for keel or surface and switch NMEA 2000 PGNs (Parameter Group Numbers) on or off. The advanced speed calibration takes your own figures for up to four heel angles and ten speeds. Airmar points out that this used to need expensive PC software.

The sensor fits most Airmar 2-inch (51 mm) thru-hull housings, including the DT800, DST820, UST850 and UDST820. That means a retrofit can reuse the hole you already have. Airmar lists speed from 0.1 to 35 knots, depth from 0.6 to 100 m and a 9-16 V supply. It comes with a 6 m NMEA 2000 cable.

Airmar gives no price for TriSonic or TriSonic 2 in its release or on its product page – so ask your dealer.

I like the idea. A paddlewheel full of growth is the classic reason a log stops reading, and on a cat you normally fit two of everything anyway. What I would like to know is how your plotter handles two depths under two hulls. Airmar doesn’t say if that shows up as two depth sources on your MFD (Multifunction Display) or as one. I think that is a good question for the stand.

We also covered Airmar’s Universal Pocket Mount for 1 kW to 3 kW transducers this week.

Sources: Airmar TriSonic press release, 4 August 2026 (PDF) · Airmar TriSonic Smart Sensor product page · Airmar TriSonic 2 on the METSTRADE product listing · Airmar METSTRADE exhibitor page (stand 01.205)